This four-pack of 15-foot raw wire speaker cables is designed for musicians, installers, and DIY audio enthusiasts who need reliable connections for speakers with binding post terminals. Whether you're wiring a home theater system, building custom PA cables, or connecting studio monitors, these shielded cables deliver clean signal transmission without the markup of pre-terminated options.

Each cable features 16-gauge copper conductors wrapped in durable black PVC jacketing. The shielded design prevents interference from nearby electrical sources, ensuring your audio signal stays clean from amplifier to speaker. Raw wire terminations give you maximum flexibility to strip and connect directly to binding posts or solder on your preferred connectors.

The 16-gauge wire handling capacity makes these cables suitable for most home audio and small venue applications. At 15 feet, they provide enough length for typical room setups while minimizing signal loss. The shielded construction is particularly valuable in installations where cables run near power lines or wireless equipment.

Perfect for connecting bookshelf speakers, studio monitors, or small PA speakers in venues up to 100 people. The raw wire ends work directly with red and black binding posts found on most consumer and prosumer speakers. You can also solder on 1/4-inch, Speakon, or banana plug connectors as needed.

Each cable comes ready to use with clearly marked positive and negative conductors. Backed by Seismic Audio's one-year warranty and built for long-term reliability in both permanent installations and portable setups.

Technical Specifications

Frequently Asked Questions

What gauge wire do I need for my speakers?

16-gauge wire is suitable for most home audio and small PA applications up to about 100 watts per channel at 15 feet. For higher power applications or longer runs, consider 14 or 12-gauge wire. These cables work well with bookshelf speakers, studio monitors, and smaller PA speakers in typical room and small venue setups.

Can I add connectors to these raw wire cables?

Yes, the raw wire ends are designed for maximum flexibility. You can strip the ends and connect directly to binding posts, or solder on 1/4-inch plugs, Speakon connectors, or banana plugs as needed. The conductors are clearly marked for positive and negative polarity to ensure proper phasing.

Why choose shielded speaker cable over unshielded?

Shielded cable prevents electromagnetic interference from power lines, wireless equipment, and other electronic devices that can cause hum or noise in your audio signal. This is particularly important in permanent installations where cables run near electrical wiring or in venues with lots of wireless microphones and lighting equipment.

Will these cables work for outdoor events?

While the PVC jacket provides basic weather resistance, these cables are primarily designed for indoor use or covered outdoor areas. For direct exposure to rain or extreme weather, consider cables with more robust outdoor-rated jacketing. The 15-foot length works well for small outdoor gatherings or covered pavilions.

How do these compare to pre-made speaker cables with connectors?

Raw wire cables give you more flexibility and typically cost less than pre-terminated options. You get exactly the connectors you need rather than being limited to what's available. However, they require some DIY work to strip and connect properly. If you prefer plug-and-play convenience, check out Seismic Audio's selection of pre-made speaker cables.

WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer. For more information, go to: www.P65Warnings.ca.gov