The RW25 Four-Pack delivers four 25-foot raw wire speaker cables designed for custom installations, home audio systems, and DIY cable builders who need professional-grade wiring without pre-attached connectors. These cables work perfectly with speakers, receivers, and amplifiers that use binding post connections with red and black terminals.

Each cable features 16-gauge shielded wire construction that provides clean signal transmission for both home and light commercial applications. The PVC jacket protects the cable from wear while maintaining flexibility for routing through walls, racks, or around stages.

The 16-gauge wire gauge handles power loads suitable for most home theater and small venue setups, while the shielded design minimizes interference from nearby electrical sources. At 25 feet, these cables give you the length needed for most room installations or small mobile setups. The raw wire ends strip easily and connect securely to binding posts, spring terminals, or can be terminated with your choice of connectors.

Use these cables for permanent home theater installations, connecting powered studio monitors, building custom PA speaker cables, or creating specific-length connections for installed sound systems. The four-cable pack covers a typical surround sound setup or provides spares for mobile applications.

Simply strip the wire ends and connect positive to positive, negative to negative on your speakers and amplifiers. The cables come ready to use with no additional hardware required.

Seismic Audio backs these cables with a one-year warranty and fast shipping. Professional-grade construction at a practical price point for installers and audio enthusiasts.

Technical Specifications

Frequently Asked Questions

What gauge wire do I need for my speakers?

16-gauge wire handles most home audio applications and speakers up to moderate power levels. This gauge works well for bookshelf speakers, surround sound systems, and most home theater setups within 25 feet. For high-powered subwoofers or very long runs, consider thicker 12 or 14-gauge wire.

Can I add connectors to these raw wire cables?

Yes, these cables are designed for custom termination. You can solder on 1/4-inch plugs, Speakon connectors, banana plugs, or spade terminals to either end. Many installers prefer raw wire cables for this flexibility, allowing them to create exactly the connector combination they need.

How do I connect raw wire cables to my speakers?

Strip about 1/2 inch of insulation from each wire end, then connect the positive (usually marked) wire to the red terminal and negative wire to the black terminal on both your amplifier and speaker. Most home speakers and receivers use binding posts, spring clips, or screw terminals that accept bare wire directly.

Will these cables work for outdoor speakers?

While these cables have PVC jackets that provide basic protection, they're designed primarily for indoor use. For permanent outdoor installations, consider cables rated specifically for direct burial or outdoor exposure, which have more robust weatherproof jackets.

How many cables do I need for a surround sound system?

A basic 5.1 surround system needs five speaker cables (left, right, center, and two surround speakers), so this four-pack covers most of your needs. You'll need one additional cable for the fifth speaker, or consider using the fourth cable for a subwoofer if it accepts speaker-level inputs.

WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer. For more information, go to: www.P65Warnings.ca.gov